| View previous topic :: View next topic |
| Author |
Message |
Mod Coupe
tinkerer
Joined: 10 Nov 2002
Posts: 56
|
 Posted: Fri Aug 08, 2003 9:13 am Post subject: ATTN Josh |
 |
|
| How do you adj pivot point? |
|
| Back to top |
|
 |
Josh
backyard mechanic
Joined: 04 Oct 2001
Posts: 602
|
| Posted: Fri Aug 08, 2003 7:56 pm Post subject: Re: ATTN Josh |
|
|
| You'll have to take the gearbox back off the engine again. Then remove the fork arm (the bit that the clutch cable pulls on) After you remove that with the thrust brearing you will see when the whole arm pivots on. That pivot is on a thread with a lock nut. Loosen the lock nut and wind the pivot point out about 1 - 2 turns and tighten the lock nut back up... Hope this helps? |
|
| Back to top |
|
|
|
