View previous topic :: View next topic |
Author |
Message |
SAM 180 tinkerer
Joined: 06 May 2002 Posts: 482
|
Posted: Wed Aug 27, 2003 2:59 pm Post subject: Replacing Lower Ball Joints |
|
|
is there a way you can replace your lower ball joints without taking off your lower control arm, cos mine just snapped while reversing out a driveway... and my friends said theyd give me a hand if there is a way... |
|
Back to top |
|
|
Gene FJ20DET hod rodder
Joined: 06 Oct 2001 Posts: 9163 Location: brisbane
|
Posted: Wed Aug 27, 2003 3:25 pm Post subject: Re: Replacing Lower Ball Joints |
|
|
no u have to take the arm out.
its only 3-4 bolts work
unless all ya mates wanna help out lift the car up into a pres :d hehe
u need them pressed in. _________________
|
|
Back to top |
|
|
UaniAndGeMini tinkerer
Joined: 15 Oct 2002 Posts: 63
|
Posted: Wed Aug 27, 2003 9:26 pm Post subject: Re: Replacing Lower Ball Joints |
|
|
yeah i tried puttin em on without taking it off and it impossble cant get em in far enough....mine snapped while driving round a corner but i hit a kerb goin 50 ks the weekend bfore that when i whipped it around a corner lost it doin snakies ...then a week later my upper snapped so check the upper aswell if u did sumthing stupid...for ex hittin a kerb lmao...upper are piss easy to put on |
|
Back to top |
|
|
SAM 180 tinkerer
Joined: 06 May 2002 Posts: 482
|
Posted: Wed Aug 27, 2003 9:33 pm Post subject: Re: Replacing Lower Ball Joints |
|
|
nah i was just reversing out a driveway... took an hour and a half to get it onto car trailor...after trying so many methods, in the end we jacked up the arm and g clamped it while taking off 15" mag and putting on stockie with nuts as spacer in order for the wheel to not hit the tyre... |
|
Back to top |
|
|
GasGem backyard mechanic
Joined: 05 Nov 2001 Posts: 755
|
Posted: Thu Aug 28, 2003 12:57 am Post subject: Re: Replacing Lower Ball Joints |
|
|
yes there is a way to change lower ball joint.
1.support car well.... remove spring.
rest lower arm on solid wood with room for ball joint to come out, heat lower arm with oxy, and bash ball joint with big hammer until it comes out.
2. freeze new ball joint over night in freezer. then reheat lower arm and put ball joint in place and this time sit the ball joint on the wood then hit arm carefully with hammer until the balljoint is abck in it's place.
done this a could of times works fine unless some dick head previously welded the back of the balljoint in place....
cheers
Eggy
cheers |
|
Back to top |
|
|
|