| View previous topic :: View next topic |
| Author |
Message |
Gemmy
backyard mechanic
Joined: 06 Oct 2001
Posts: 533
|
 Posted: Mon Oct 08, 2001 11:23 am Post subject: Lowering regs in QLD |
 |
|
| What is the min height off the ground for lowering in QLD? I heard it was 3 or 3 1/2 inches from teh lowest point on the car. Any ideas ? |
|
| Back to top |
|
 |
CuGem
backyard mechanic
Joined: 07 Oct 2001
Posts: 599
|
| Posted: Mon Oct 08, 2001 3:31 pm Post subject: Re: Lowering regs in QLD |
|
|
G'day,
The Queensland transport booklet says the road clearance of a car must not be less than 100mm measured at any part of the vehicle other than the wheel rim or brake backing plates. Lesser clearance may be specified by a manufacturer. The suspension travel to bump must not be altered by more than 1/3. Coil springs must not be cut. |
|
| Back to top |
|
|
Kizza
tinkerer
Joined: 06 Oct 2001
Posts: 440
|
| Posted: Mon Oct 08, 2001 10:07 pm Post subject: Re: Lowering regs in QLD |
|
|
yeah its 100mm
if ya go to qld transport site, then go into the cars section, then modification section theres a booklet in adobe format with all the specs on what u can do on your car without having to get a mod plate and inspection/engineers cert.
theres stuff on tyres scoops lights ect
hope this helps
kizza |
|
| Back to top |
|
|
Gemmy
backyard mechanic
Joined: 06 Oct 2001
Posts: 533
|
| Posted: Mon Oct 08, 2001 10:55 pm Post subject: Re: Lowering regs in QLD |
|
|
| Thanx guys !! 100mm sounds like what I heard recently .. 3 1/2 inches basically |
|
| Back to top |
|
|
|
