32/36 Webber --(Jeff)

old forum · hod rodder Joined: 04 Oct 2001 Posts: 15499

hello all
i have a Tf gemini that i am doin up a bit
i have put a webber on it of an cortina as this is what i have been told u do
i also have a high comp head with DIY port work and extractors and cold air intake (makes huge differance)

What size jets and emultion tubes do u normaly run
so i can get a guide

i get 0 - 100 in low 10 sec as is or high 11- low 12 with out cold air

old forum · hod rodder Joined: 04 Oct 2001 Posts: 15499

don't take anyones word for it, jets change greatly from engine to engine even for the same type. go to a bookshop and get the haynes manual for webber tuning, i used it to tune twin 40ml idfs and they worked sweet. also watch out when buying emulsion tubes and jets as if you buy the wrong size most places wont take them back. it can get very expensive

old forum · hod rodder Joined: 04 Oct 2001 Posts: 15499

I have the book but cant make sences on how to get the jets ???????
it dosnt help much

old forum · hod rodder Joined: 04 Oct 2001 Posts: 15499

go to the back of the book where it has all of the jet sizes for the different makes and models. find an engine of the same size and configuration (ie. inline 4 )and which uses a 32/36 standard. this should be a good starting point, this is what i did. but any amount of home tuning is never going to match professional dyno time.

MR_GEMI · Posted: Mon Oct 07, 2002 7:01 pm Post subject: Re: 32/36 Webber --(ben)