Cuz tinkerer
Joined: 04 Feb 2002 Posts: 82
|
Posted: Wed Nov 19, 2003 3:49 pm Post subject: Sourcing a head!? |
|
|
Ok,
i have the feeling i have a small head gasket leak water to oil, so i'm taking this oppertunity upgrade my head.
A few questions: How easy is a tx big valve head to find (I'm in melb)?
There is few do it yourself wreckers around, should i try them? Where else can i try
What else should i check other than the actual head surface with a straight edge?
How do you check the cam tunnel?
What other dodgy stuff should i look out for (Water jackets, cracks etc)?
Where is good place in melb to get gem head work done and what is the least expensive way to get a bit more out of the head?
I know shaving is relativley inexpensive to up the compression, how good/expensive is porting and polishing? |
|