View previous topic :: View next topic |
Author |
Message |
HONES petrol head
Joined: 04 Feb 2002 Posts: 1786
|
Posted: Wed Nov 26, 2003 8:24 pm Post subject: Todays POP QUIZ |
|
|
QUESTION:
Whats wrong with my engine?
I'm losing coolant over a couple days but not overheating.
I blow a lot of steam when i am started up and i only start on 2 or 3 cylinders for about 15 seconds. I'm fine after that and still blow a small amount of smoke.
ANSWER:
my head?
head gasket?
other? please explain in detail.
Thankyou.
Doing compression test in a coupla days, ill let u know.
Hones |
|
Back to top |
|
|
DR_GEM tinkerer
Joined: 29 Apr 2002 Posts: 92
|
Posted: Wed Nov 26, 2003 9:19 pm Post subject: Re: Todays POP QUIZ |
|
|
cracked/warped head (allowing water to seep through to combustion chamber thus explaining your steamy mornings (no pun intended) - try some chemiweld - 10 bucks and will hold out for 2 or 3 months until u fix it.
i bet its on number 3......... |
|
Back to top |
|
|
FullGrownGem rice boy
Joined: 07 Feb 2003 Posts: 49
|
Posted: Wed Nov 26, 2003 9:23 pm Post subject: Re: Todays POP QUIZ |
|
|
You could have a hole in your timing cover case..i had a similar problem justtake it off and check it out, then get it welded if it has a hole...fairly simple |
|
Back to top |
|
|
ONLYA4 petrol head
Joined: 12 May 2003 Posts: 1114
|
Posted: Wed Nov 26, 2003 9:51 pm Post subject: Re: Todays POP QUIZ |
|
|
Change your oil, if the "oil" that comes out of the sump is creamy white shit, then you got a fucked head or blown head gasket. Just like me Yeah, do what he said and get some chemiweld into the bitch, seals up everything, its good shit |
|
Back to top |
|
|
Racegem backyard mechanic
Joined: 30 Jan 2002 Posts: 987
|
Posted: Thu Nov 27, 2003 2:33 pm Post subject: Re: Todays POP QUIZ |
|
|
Before you start it in the morning, take the plugs out and crank the starter over. Take note of which plug hole shoots out water/coolant. (careful not to get drenched) If this is the case, either head gasket or small crack or hole in the head. Unless it's been overheated before, it's unlikely that it's cracked. Unless it's been run without coolant additive for ages, it's unlikely to be corroded to cause a hole.
Yonnee. |
|
Back to top |
|
|
Blue TG tinkerer
Joined: 10 Feb 2003 Posts: 183
|
Posted: Fri Nov 28, 2003 5:15 pm Post subject: Re: Todays POP QUIZ |
|
|
just to be the worst... it can be a cracked block, but usually the head goes.
check the oil for white shit and water.
only takes 30 mins to crack a head off, sus the gasket and check its a true straight edge |
|
Back to top |
|
|
|