View previous topic :: View next topic |
Author |
Message |
RUBY tinkerer
Joined: 29 May 2002 Posts: 107
|
Posted: Thu Nov 14, 2002 11:05 am Post subject: will i blow holes? |
|
|
I have a worked 1600 hed on a 1600 block, wat if i put the head on my 2ltr block? or even a 2.3ltr block? is it gunna fark up? |
|
Back to top |
|
|
beasty tinkerer
Joined: 07 Oct 2002 Posts: 88
|
Posted: Thu Nov 14, 2002 3:02 pm Post subject: Re: will i blow holes? |
|
|
A worked head will work fine on a G200.
it might not supply enough airflo for the 2.3lt
Most people put worked 1600 heads on the G200 it would be even better if it is the early big valve head. |
|
Back to top |
|
|
Knobby tinkerer
Joined: 09 Oct 2001 Posts: 172
|
Posted: Thu Nov 14, 2002 9:58 pm Post subject: Re: will i blow holes? |
|
|
a 1.6L head on a 2L bottom end, is more likely to blow head gaskets, but it works fine. its like if you buy three scratchis, you are more likely to win, but its not definite...
i have no idea if a 1.6L head will ven fit on a 2.3L bottom end, but it would have pretty damn high compression!
knobby... |
|
Back to top |
|
|
Stoktg tinkerer
Joined: 05 Jan 2002 Posts: 113
|
Posted: Fri Nov 15, 2002 4:35 am Post subject: Re: will i blow holes? |
|
|
go well on a g200, may require avgas though to stop the pinging if the head has had a lot shaved off it. the 2.3 is a 4zd1 motor, completely different design to the G series so if you can make it fit it will be a miracle. |
|
Back to top |
|
|
|