HotGemini.com - Holden Gemini heaven
Home What's New About Help Contact




Someone with a rotor conversion

 
Post new topic   Reply to topic    hotgemini.com Forum Index -> General Gemini Chat
View previous topic :: View next topic  
Author Message
Loz
backyard mechanic


Joined: 05 Oct 2001
Posts: 943

PostPosted: Thu Mar 06, 2003 12:49 pm    Post subject: Someone with a rotor conversion Reply with quote

I just bought an 808 wagon(very heap and will have the roof chopped of to be a summernats cruiser) with an unfinished 13B conversion in it. Its a twin dizzy engine and I want to know how to wire up the coils when going to the single coil 808 setup. Parrallel, series, something else??

Cheers
Loz
Back to top
View user's profile Send private message Send e-mail
WAY2LOWatwork
tinkerer


Joined: 02 Apr 2002
Posts: 188

PostPosted: Thu Mar 06, 2003 12:51 pm    Post subject: Re: Someone with a rotor conversion Reply with quote

13b's arent twin dizzys!
dodgy
Back to top
View user's profile Send private message Send e-mail
Loz
backyard mechanic


Joined: 05 Oct 2001
Posts: 943

PostPosted: Thu Mar 06, 2003 1:13 pm    Post subject: Re: Someone with a rotor conversion Reply with quote

Oops my bad. I meant to write twin coil. Any ideas?

Loz
Back to top
View user's profile Send private message Send e-mail
WAY2LOWatwork
tinkerer


Joined: 02 Apr 2002
Posts: 188

PostPosted: Thu Mar 06, 2003 2:24 pm    Post subject: Re: Someone with a rotor conversion Reply with quote

TRY THIS.
i think mine is set up like so.....
run a 12v power source to the coils, thru a relay or ignition, this can be bridged between both coils.... then the negatives connect to the distributor. 1 is going to be leading and the other trailing. connect them to the points so that they fire at the right times. then connect them with the leads to the dizzy, make sure the leading coil goes to the correct 1, same as the trailing.
this might help, a bit vague, but ill check properly when i get home
Back to top
View user's profile Send private message Send e-mail
cni
tinkerer


Joined: 25 Sep 2002
Posts: 72

PostPosted: Thu Mar 06, 2003 3:21 pm    Post subject: Re: Someone with a rotor conversion Reply with quote

also u might wanna go ask at like www.3rotor.com on the forum there or www.badrotor.co.nz in there forum they have a pretty good tech section and they should be able to give more advice!!!!!

Mazda 808's r the shiznits.......
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    hotgemini.com Forum Index -> General Gemini Chat All times are GMT + 10 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group
© HotGemini.com 2000-2007 | Privacy Policy | Terms of Use | Site Map